Water supply fittings

Truma Crystal Filter Housing and Compact Housing - The complete housings have been superceded by the Ultraflow, but some parts are still available. To see schematic diagrams please click through to next page.

Allows a tap with a 1/2" barbed water connection to be adapted to 12mm push fit. Hose length approx 20cm.

Truma Ultraflow Water Inlet Filter + Spare Parts. To see schematic diagrams please click through to next page.

Pressure Switches

Push Fit Fittings 10mm and 12mm

Push Fit Fittings 15mm

Floë Drain Down Systems, The flow system is a simple and cost saving way to drain down your water system.

Water Filler Caps for Caravan and Motorhome Water Systems

Comet water inlet with sliding lid.

Ball valve for fitting to the side connection of the Aquaroll, Royal Aquarius and Roly Poly water containers to allow a mains water connection.

Flow Valve for the Water Hog - latest version

Non Return Valves

Reich Push-Fit Connectors

Flexible Pipe Barbed Connectors

Whale System 12 Semi Rigid Pipework is the quick and easy way to plumb your caravan, boat or motorhome.

Hep2 O Push Fit Water Fittings. 15mm push fit fittings commonly used in static caravans.

A variety of water hose connections.

Bulkhead and Tank Fittings. Through wall fittings for bulkheads and water tanks.

Cold water washers in two sizes

Fresh and Waste Water Level Indicator Kits

Nylon Pipe Clips, quick and easy screw mounted fixing, ideal for pipes and cables.

Drain tap blue with 3/4" BSP thread and back nut.

Water inlet with locking lid. Size 160 x 130 mm

Reich Hot Water Supply Connection (white). With pre-mixer and shower-tap, without lock and without switch. PLEASE NOTE IF OUT OF STOCK THERE IS A 4-8 WEEK DELAY

If out of stock there may be a 4-8 weeks to delay. Screw cap for inboard fresh water tank with through fitting to suit flexible hose and hole for submersible pump electric cable. Filler cap for tank with screw nozzle,cable passage and vent valve Intelligent and cust...

Read More...

Reich fresh water distributor, 5 outlets, with drain valve. Plastic. 5 outlets on base, with a connection at each end, one for the inlet and the second is normally blanked. Blanking plug 256224. PLEASE NOTE IF OUT OF STOCK THERE IS A 4-8 WEEK DELAY

Sub Pump Adaptor for fitting into the roof of a water tank to allow connection to a submersible pump.

For REICH water sockets and supply connections For part as seen connector you will require 271715 With nozzle. PLEASE NOTE IF OUT OF STOCK THERE IS A 4-8 WEEK DELAY

Mains water adaptor kit including hose for the Aquaroll, Aquarius, Water Hog, Roly poly and Aqua Caddy. Provides a constant water feed to the water container from the mains supply, controlled by a ball valve. Contains: Float Valve Assembly 7.5 Mtr Food Grade Hose ...

Read More...

Ball valve which screws into the side connector of the Water Hog or Aqua Caddy to allow a mains water supply to the water tank.